above the audio meter. In the
Source properties dialog, update the settings that apply:To update your audio source’s properties, click Source
Properties above the audio meter. In the
Source properties dialog, update the settings that apply:
|
Source Property |
Description |
|
Boost 20dB |
When using XLR (Balanced), select this check box to amplify the audio input’s signal by 20dB. |
|
Channel Pair |
When using embedded HDMI or SDI, select the digital audio input channels. The options available will depend on your Recorder. |
|
Output Gain |
Adjust the gain applied to the audio output (what your viewing audience hears). The Output Gain has a range of -95.625 dB to +0.000 dB with a default setting of +0.000 dB. |
|
Line Out Gain |
Adjust the gain applied to the line out audio signal. |
|
Meter dB Range |
Adjust the decibel ranges shown in the audio meter. The value that you set will be the lowest dB value shown on the meter. |
|
Reset |
Return all settings to their default values. |
|
Signal Type |
Verify the selected audio input. This value is read-only. |
If using an analog source,
additional settings will display that allow you to adjust the gain and decibel
ranges shown in the audio meter. Please note that you CANNOT use the slider to
adjust the volume when using digital audio inputs.
The settings available in the audio
source properties menu will vary by Recorder and input type so some items listed
above may not be available when you access these settings.
Capture tab: audio source properties (XLR (Balanced) input)